Siemens SINUMERIK 840D sl Commissioning Manual page 222

Online Help (HE1)
1 Programming Help
The following technology codes can be specified:
"m"
"t"
"g"
"s"
"p"
"a"
TEXTFILES section
The paths (path\name) used for the Short Help text files on which the help function
is based are parameterized in the section [TEXTFILES].
The help function accesses the following text files:
• Siemens "DH\CST.DIR\IFS_GR.COM"
• Machine manufacturer "DH\CMA.DIR\IFM_GR.COM" (any file name)
• End user "DH\CUS.DIR\USER_GR.COM" (any file name)
(is also entered via "Settings")
!
Important
The path for the Siemens text file "DH\CST.DIR\LFS_GR.COM" must exist
otherwise an error message is output.
There are different parameterization options for the names of the text files when
assigning the text path.
The following table lists the parameterization options and their interpretation by the
Help function.
Table 1-1
Parameters for the text file
FileName.com
File name_XX.com
(XX=language code, e.g. "gr" for
German. For a list of language codes,
see also Chapter 2 Section "Alarm
Help")
Example: ENDUSER=CUS.DIR\IFM_.COM
First of all, the language-independent text file "IFM.COM" is opened in the path
"C:\DH\CUS.DIR\" by default or, if the language-independent text file does not
exist, the relevant language-dependent text file (e.g. "IFM_GR.COM") is opened.
HE1/1-10
SINUMERIK 840D sl/840D/840Di/810D HMI Installation and Start-Up Guide (IAM) – 08/2005 Edition
= milling
= turning
= grinding
= nibbling
= punching
= display all technologies
Interpretation
The language-dependent text file is
read out.
The language-dependent text file is
read out.
© Siemens AG, 2005. All rights reserved
08/2005