Siemens SINUMERIK 840D sl Commissioning Manual page 411

08/2005
Note
This function is not available if the MACHINE operating area is suppressed from
the HMI startup.
Error messages to the PLC
The HMI outputs the following error values to the PLC via DB19.DBB27:
0 No error
1 Invalid number for control file.
(value in DB19.DBB16 < 127 or invalid)
2 Unable to read DB19.DBB15
3 Control file /BD.DIR/PLC_IN_OUT_xxx.TEA not found.
(value in DB19.DBB16 invalid)
4 Invalid index in control file. (incorrect value in DB19.DBB17)
5 Selected job list in control file could not be opened.
6 Error in job list (job list interpreter returns error)
7 Job list interpreter returns empty job list
9 Error while executing job list
Conflict resolution
When a job list is executed manually (via operator input), prompts can occur in the
protocol, e.g., if an MPF file is located both on the NC as well as on a hard disk and
the two MPF files are different. The default response to the AR server can be
entered in the MASCHINE.INI configuration file.
The default setting is "yes," i.e., all prompts are responded to with Yes. If "no," all
prompts are responded to with No.
[PLC_REQUEST]
DefaultAnswer=yes
Multiple operator panel fronts/NCUs M:N (for SINUMERIK powerline)
In an m:n system, HMI Advanced is assigned to a netmaster NCU/PLC in
NETNAMES.INI. The bus address of the NCU is configured in the [param network]
section.
e.g.
This setting for the netmaster NCU/PLC means that data transfer is only activated
by the NCU/PLC with the symbolic name NCU_LEFT.
Machine manufacturer
See machine manufacturer's specifications.
For a description of DB 19, refer to /FB/ A2, Various Interface Signals
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Installation and Start-Up HMI (IAM) - 08/2005 Edition
[param network]
netmaster= NCU_LEFT
Commissioning HMI Advanced (IM4)
2 Setting Functions and Parameters
IM4/2-17