Simulation Of Part Programs; Marginal Conditions; Data Lists - Siemens SINUMERIK 840D sl Function Manual

3.4

Simulation of part programs

3.4
Windows 32s, version 1.30.166.0 or higher, must be installed in order to operate part
program simulation.
For notes on operation, see
References:
/BA/ Operating Manual
3.5

Marginal conditions

3.5
The "Operation via PG/PC" function is available in the basic version with software version
3.1 and higher. With software version 3.1, the number of NCUs which may be connected is
limited to one and the number of operator panel fronts to two. One of these must be an
OP030.
With software version 3.2 and higher, an operator panel front with MMC 100 or MMC
102/103 can also be connected with up to three NCUs.
3.6

Data lists

3.6
No signals or machine data are required for this function.
Extended Functions
Function Manual, 09/2009, 6FC5397-1BP20-0BA0
B4: Operation via PG/PC - only 840D sl
3.4 Simulation of part programs
281