Siemens SINUMERIK 840D sl Commissioning Manual page 508

Commissioning HMI Advanced (IM4)
2 Functions/Parameterization
NCG_4_Label=NC4
NCG_4_Text=$80852
NCG_4_Ico=cm_poly_dr_reaming.bmp
NCG_4_Level=0
...
[CYC86]
;boring
NCG_1_Label=NC1
NCG_1_Text=$80666
NCG_1_Ico=cm_poly_dr_bore.bmp
NCG_1_Level=0
NCG_2_Label=NC2
NCG_2_Text=MCALL CYCLE86
NCG_2_Ico=cm_poly_dr_bore.bmp
NCG_2_Level=0
[CYC83]
;deep hole drilling
NCG_1_Label=NC1
NCG_1_Text=$80794
NCG_1_Ico=cm_poly_dr_deepdrill.bmp
NCG_1_Level=0
NCG_2_Label=NC2
NCG_2_Text=MCALL CYCLE83
NCG_2_Ico=cm_poly_dr_deepdrill.bmp
NCG_2_Level=0
Explanations:
Two graphics-supported supported cycles are shown here by way of example.
The following lines appear in place of the cycle in the NC program:
;NCG#CYC82#\CST.DIR\bohren.com#NC1#2#*NCG;*RO*;*HD*
;#1#1#1#1#1###"M3"####1##1#*NCG;*RO*;*HD*
CYCLE82(1,2,3,4,,0)
;#END#*NCG;*RO*;*HD*
[ProgSupport_User]
No.
Here, the number of the following entries must be specified.
NCG_1
Entries of individual search texts or name of cycles.
Generally, this is the text that is found in the NC program after "NCG#".
In the example above, this would be "CYC82".
IM4/2-114
SINUMERIK 840D sl/840D/840Di/810D Installation and Start-Up HMI (IAM) - 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005