Extensions In Hmi Advanced; Action: Special Cases In Hmi Advanced; Task, State, And Action: Special Cases In Hmi Embedded - Siemens SINUMERIK 840D sl Commissioning Manual

Expanding the Operator Interface (BE1)
5 Configuring OP Hotkeys and PLC Keys
; Activate mapping of the Menu Select key (F10) to
; hotkey 8,
; key has no function
Key8.0 = <empty> ; No reaction assigned
5.1.4

Extensions in HMI Advanced

The machine manufacturer can overload the entries in Keys.ini in directory mmc2
with his own settings. These settings can be entered in one of the following
directories
\user and
\oem
searched earlier during processing. Only deviations in the settings must be stored,
not the complete block.
5.1.5

Action: Special cases in HMI Advanced

HMI Advanced
The ETC key, Action 17, has no effect.
5.1.6

Task, State, and Action: Special cases in HMI Embedded

• The range of values for the Task is limited to between 0 and 15.
• HMI Embedded always selects the last screen combination that was active
before the task change. (State not configured).
• The range of values for State is limited to 0. Only the main menu of the
operating area can be selected.
• The range of values for Action is between 0 and 17 :
SK horizontal 1 to 8,
SK vertical
Recall
Etc
BE1/5-126
SINUMERIK 840D sl/840D/840Di/810D HMI Installation and Start-Up Guide (IAM) – 08/2005 Edition
1 to 8,
and
limited.
© Siemens AG, 2005. All rights reserved
08/2005