Header.ini - Siemens SINUMERIK 840D sl Commissioning Manual

Commissioning HMI Advanced (IM4)
2 Functions/Parameterization
[PRELOAD]
TOOLS=0
CYCLES=1
CYCLEINTERFACE=2

2.5.9 HEADER.INI

[CondStopIcons]
DefaultIcon=CondWait.bmp ;0 = No wait state
1=CondStop.bmp
2=CondStop.bmp
3=CondStop.bmp
4=CondStop.bmp
5=CondStop.bmp
6=CondStop.bmp
7=CondStop.bmp
8=CondStop.bmp
9=CondStop.bmp
10=CondWait.bmp
11=CondWait.bmp
12=CondStop.bmp
13=CondWait.bmp
14=CondWait.bmp
15=CondWait.bmp
16=CondWait.bmp
17=CondStop.bmp
18=CondStop.bmp
19=CondStop.bmp
20=CondWait.bmp
21=CondWait.bmp
22=CondStop.bmp
23=CondStop.bmp
24=CondWait.bmp
25=CondWait.bmp
26=CondWait.bmp
27=CondWait.bmp
28=CondWait.bmp
29=CondWait.bmp
IM4/2-86
SINUMERIK 840D sl/840D/840Di/810D Installation and Start-Up HMI (IAM) - 08/2005 Edition
;=1: TO_INI.INI and TO_ADDON.INI are preloaded by DPNCSIM.EXE
;=0: TO_INI.INI and TO_ADDON.INI are loaded by simulation
;= 1: all cycles are preloaded by DPNCSIM.EXE
; if section MAIN, entry CYCLE is set, additionally all cycles from
shadow directory are preloaded by DPNCSIM.EXE
;= 0: cycles are loaded by simulation, if cycle is called
;=2: load for simulation to \CUS.DIR, \CMA.DIR or \CST.DIR (default)
; load only cycles from NCK
; only evaluated if [MAIN]CYCLE is set and [PRELOAD]CYCLES=1
;=0: load all cycle (from NCK and MMC) for simulation to
; \CUS.DIR, \CMA.DIR or \CST.DIR
; only evaluated if [MAIN]CYCLE is set and [PRELOAD]CYCLES=1
;=1: use the cycle interface in \DP.DIR\SIM.DIR
;No NC ready
;No ModeGroup ready
;EMERGENCY STOP active
;Alarm active with stop
;M0/M1 active
;Block ended in SBL mode
;NC Stop active
;Read-in enable missing
;Feed enable missing
;Dwell active
;Aux. function acknowledgment missing
;Axis enable missing
;Exact stop not reached
;Waiting for positioning axis
;Waiting for spindle
;Waiting for other channel
;Waiting for feed override
;Error in NC block
;Waiting for external NC blocks
;Waiting for synchronous action
;Block search active
;No spindle enable
;Axis feed override 0
;Waiting for tool change acknowledgment
;Gear step change
;Waiting for position control
;Waiting for thread cut
;Reserved
;Waiting for punching
© Siemens AG, 2005. All rights reserved
08/2005