Oemframe.ini - Siemens SINUMERIK 840D sl Commissioning Manual

08/2005
[Channel15]
logNCName = NCU_1
ChanNum = 5
[Milling2]
logChanList = Channel21, Channel22, Channel23, Channel24, Channel25
[Channel21]
logNCName = NCU_2
ChanNum = 1
[Channel22]
logNCName = NCU_2
ChanNum = 2
[Channel23]
logNCName = NCU_2
ChanNum = 3
[Channel24]
logNCName = NCU_2
ChanNum = 4
[Channel25]
logNCName = NCU_2
ChanNum = 5

2.5.18 OEMFRAME.INI

[SysMeter]
; let OEMFrame just look for Windows which have been
; created by the OEMApp
; default is 0 (means NO)
;fSearchOnlyForTaskWindow=1
; let OEMFrame delay INIT_COMPLETE, if set to -1,
; OEMFrame will not send any WM_INITCOMPLETE at all,
; this value must be given in microseconds
;nDelayInitComplete=10000
; switching WS_SYSMENU, WS_MINIMIZEBOX and WS_MAXIMIZEBOX off
WindowStyle_Off = 720896
; other possible task entries aren't used
WindowStyle_On =
x =
y =
Width =
Height =
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Installation and Start-Up HMI (IAM) - 08/2005 Edition
Commissioning HMI Advanced (IM4)
2 Functions/Parameterization
IM4/2-105