Hardware/Software Requirements - Siemens SINUMERIK 840D sl Commissioning Manual

08/2005

1.1 Hardware/Software Requirements

Introduction
This Installation and Start-Up Guide describes the procedures for system startup of
the PCU 50 and PCU 70 with HMI Advanced software.
For further reading on special NCK, HMI, PLC, or drive functions, refer to the
applicable descriptions of functions and manuals (see "Documentation").
Software
Depending on the order details, the HMI Advanced software may be pre-loaded on
the PCU 50/PCU 70 on delivery. If the HMI Advanced software is not pre-loaded on
the PCU 50/PCU 70 (e.g., PCU 50 is supplied without system software), the HMI
software can be installed on the PCU 50/PCU 70 from the CD supplied using the
Service menu.
This also applies to SW updates (see "SW Installation/SW Update").
Required equipment and accessories
To install the HMI Advanced software on the PCU 50/PCU 70, you need the
following:
•
PC or programming device with CD drive
•
Network connection
•
USB memory
Operating system
The HMI Advanced software can run on the Windows XP operating system.
Documentation
For system startup of the SINUMERIC controller, you need the following
documentation:
•
/BH/ Operator Components Manual
•
/BAD/ Operator's Guide HMI Advanced
•
/DA/ Diagnostics Guide
•
/FB/ Description of Functions Basic Machine (Part 1)
•
/IAM/ IM6 Starting up PCU Basic Software
•
/LIS/ Lists
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Installation and Start-Up HMI (IAM) - 08/2005 Edition
Commissioning HMI-Advanced (IM4)
1 General Preparations
IM4/1-9