REPLACEMENTS
FUNCTION TEST
1
.
Check that the WIRE TIES are at the correct position. Use the marks from step 4 as
reference.
2
.
Check that the CONVEYOR is seated properly. It must be as far as possible to the
front (e.g. to the INPUT FLAP).
3
.
Run a TEST CYCLE.
4
.
Check that the FILM is picked up from the CASSETTE.
5
.
Check that the FILM is transported correctly into the FILM CHUTE.
6
.
Use various FILM SIZES.
REPLACEMENT OF THE FILM PICK UP MOTOR BELT (CARRIAGE)
1
.
Do Procedure "REMOVAL OF CONVEYOR".
2
.
Remove the 3 MOUNTING SCREWS of the FILM PICK UP MOTOR.
3
.
Replace the BELT with a new one.
FUNCTION TEST
1
.
Check that the CONVEYOR is seated properly. It must be as far as possible to the
front (e.g. to the INPUT FLAP).
2
.
Run a TEST CYCLE.
3
.
Check that the FILM is picked up from the CASSETTE.
4
.
Check that the FILM is transported correctly into the FILM CHUTE.
5
.
Use various FILM SIZES.
REPLACEMENT OF FILM PICK UP MOTOR (CARRIAGE) M6
1
.
Do PROCEDURE "REMOVAL OF CONVEYOR".
2
.
Remove the 3 MOUNTING SCREWS.
3
.
Take out the 3 MOTOR WIRES from the CONNECTOR X60. Use Extraction Tool
TL1580. See figure 2-29 on the next page.
6/97
figure 2-28
2-30
SM 3477
KODAK AG, Stuttgart