Table of Contents
Advertisement
Service Guide
Device Error #39 "Plate carriage stuck"
Device Error #42: "Plate carriage stuck"
Scenario
[1] During erase, the plate carriage does not reach the Z0 sensor.
[2] During unload, the plate carriage does not reach the Z0 sensor.
Recommended Actions for Field Engineer
[1] Remove the scanner cover. (See
[2] Check the carriage position and release it if stuck.
[3] Check that the carriage flag closes the Z0 sensor when the carriage is in the lower position. When the sensor
is closed the plate carriage (Z0) indicator light J505 on the Diagnostic screen lights.
[4] Manually move the plate carriage and check that the indicator light changes status when the sensor is covered
and uncovered.
[5] Check the connector J505 on the sensor board.
[6] Check the J505 sensor and replace if broken.
172
Removing the Scanner Cover on Page
25.)
6H4869
Advertisement
Chapters
Table of Contents
