Kodak Miniloader 2000 Service Manual page 66

ADJUSTMENTS
19.
Rotate the LEFT HAND TIMING DISK in the direction of the arrow until SENSOR
B56/M_PU_EF is interrupted.
20.
Tighten the SET SCREW.
21.
Check that the FILM POCKET SUCKER BAR reaches the FRONT POSITION
without bouncing.
Press BACKSPACE twice to come back to the screen COMPONENT TEST
Select MAGAZINE MOTORS................................................................. press ENTER
Select FILM PICK UP MAGAZINE M15 ............................................ press ENTER
Select BACKWARD
Select FORWARD
22.
If the BALL BEARING is not fully engaged in the DETENT or if the FILM POCKET
SUCKER BAR does not stop without bouncing go back to step 18 else proceed with
step 25.
23.
Exit the SERVICE MODE.
Press BACKSPACE 3 times
Select LEAVE COMPONENT TEST ..................................................... press ENTER
Select QUIT ML2000 SERVICE MODE ............................................. press ENTER
Select Quit the program ............................................................................ press ENTER
24.
Insert a loaded MAGAZINE into the ML2000 (ML2000 / P M35-M).
25.
Run a few cycles; if the FILM does not interfere with parts of the CASSETTE
TRANSPORT MODULE, proceed with step 34, else proceed with step 26.
26.
Start the SENSOR TEST.
Start the SERVICE PROGRAM
Select SERVICE MODE from the GLOBAL MENU .......................... press ENTER
ENTER SERVICE MODE MESSAGE is displayed ............................ press ENTER
UNIT DATA are displayed....................................................................... press ENTER
Select COMPONENT TEST from the MAIN MENU ........................ press ENTER
Select SENSORS......................................................................................... press ENTER
Select SENSOR TEST WITH SOUND.................................................. press ENTER
6/97
figure 3-21
3-20
SM 3477
KODAK AG, Stuttgart