Kodak Miniloader 2000 Service Manual page 53

SM 3477
3
. Tilt the CASSETTE SUCKER BAR.
Start the SERVICE PROGRAM
Select SERVICE MODE from the GLOBAL MENU .......................... press ENTER
ENTER SERVICE MODE MESSAGE is displayed ............................ press ENTER
UNIT DATA are displayed....................................................................... press ENTER
Select COMPONENT TEST from the MAIN MENU ........................ press ENTER
Select SOLENOIDS ................................................................................... press ENTER
Select TILTING CASSETTE SUCKER BAR Y7.................................. press ENTER
Select SOLENOID ON
The SOLENOID Y7 will be switched on for 59 seconds. This time is limited to avoid overheating of
4
. Manually move the CASSETTE SUCKER BAR CARRIAGE forward until the
CASSETTE SUCKERS reach the ADJUSTMENT PLATE TL 4804.
5
. Check that the rear edges of the SUCKERS are 18 mm +2 -0 away from the rear of
the adjustment plate.
gently push here
6
. If the distance is not correct, loosen the RETAINERS and move the CONVEYOR
forward or backward as required, and fasten the RETAINERS. See drawing 3-10 on the
next page.
7
. If it is not possible to reach the 18 mm, bend the parts shown up or down as
required. See figure 3-10 on the next page.
KODAK AG, Stuttgart
NOTE
the SOLENOID.
figure 3-8
3-7
ADJUSTMENTS
6/97