Replacement Of Carriage Assembly Drive Belts; Function Test - Kodak Miniloader 2000 Service Manual

REPLACEMENTS

REPLACEMENT OF CARRIAGE ASSEMBLY DRIVE BELTS

1
. Do PROCEDURE "REMOVAL OF CONVEYOR".
2
. Do PROCEDURE "REPLACEMENT OF FILM PICK UP MOTOR" step 1 to 3.
3
. Mark the position of the BELT-LINKS on the MECHANISM PLATES. These marks are
used as a reference when installing the new DRIVE BELTS.
IDLER ROLLER (2)
DOWEL PIN
4
. Remove the IDLER ROLLERS.
5
. Remove the small C-RINGS at the BELT LINKS.
6
. Slide the GEAR to the right and remove the DOWEL PIN.
7
. Slide the FILM PICK UP DRIVE SHAFT to the left.
8
. Replace the BELTS.
A CARRIAGE JAM OCCURS IF THE BELT LINKS ARE NOT ALIGNED WITH THE REFERENCE

FUNCTION TEST

1
. Check that the CONVEYOR is seated properly. It must be as far as possible to the
front (e.g. to the INPUT FLAP).
2
. Run a TEST CYCLE.
6/97
Note
Replace both Drive Belts at the same time.
figure 2-30
Note
MARKS FROM STEP 3.
2-32
C-RING and BELT LINK
FILM PICK UP DRIVE SHAFT
C-RING
KODAK AG, Stuttgart
SM 3477