Kodak Miniloader 2000 Service Manual page 62

ADJUSTMENTS
7
. Check that the second counterweight is also approx. level with the top of the GUIDE.
8
. If necessary, move the CHAIN to the correct position on the GEAR.
9
. Insert aCASSETTE (18x24 ) with the tube side up and the metal edge towards the
FILM POCKET into magazine position 2. The CASSETTE is just used as a gauge.
10.
Carefully move the FILM POCKET up above level 2.
11.
Carefully rotate the FILM POCKET SUCKER BAR ARM into its fully upright position.
12.
Switch on the ML2000 (ML2000 P).
13.
Tilt the SOLENOID SUCKER BAR TILTING Y14.
Start the SERVICE PROGRAM.
Select SERVICE MODE from the GLOBAL MENU .......................... press ENTER
ENTER SERVICE MODE MESSAGE is displayed ............................ press ENTER
UNIT DATA are displayed....................................................................... press ENTER
Select COMPONENT TEST from the MAIN MENU ........................ press ENTER
Select SOLENOIDS ................................................................................... press ENTER
Select TILTING MAGAZINE SUCKER BAR Y14 ............................. press ENTER
Select ON
Do not leave the SOLENOID Y14 switched on for a long time. It becomes very hot.
14.
Manually move the FILM POCKET SUCKER BAR close to the CASSETTE in
MAGAZINE POSITION 2.
15.
Check that the MAGAZINE SUCKERS are parallel to the metal edge of the
CASSETTE. This is best seen from the front.
6/97
NOTE
figure 3-17
3-16
SM 3477
KODAK AG, Stuttgart