Kodak Miniloader 2000 Service Manual page 21

SM 3477
3
. Loosen SCREWS 1, 2 and 3.
4
. Take off the RETAINING RING and then the DRIVE PULLEY with the DOWEL PIN
and the TIMING BELT.
5
. Take off the CABLE MOUNTING BRACKET and the C-RING. Then loosen ( do not
take it out) SCREW 4. This allows to move the MOUNTING PLATE forward.
6
. Take out the MOUNTING SCREWS of the CASSETTE TRANSPORT MOTOR
(SCREWS 1, 2 and 3)
The SPACERS between the MOTOR and the MOUNTING PLATE may fall down.
7
. Take out the CASSETTE TRANSPORT MOTOR. To do so move the MOUNTING
PLATE out as far as possible.
8
. Install the new MOTOR. Fix the cable with WIRE TIES.
FUNCTION TEST.
1
. Start the CASSETTE TRANSPORT MOTOR M2
Start the SERVICE PROGRAM
Select SERVICE MODE from the GLOBAL MENU ......................... press ENTER
ENTER SERVICE MODE MESSAGE is displayed .......................... press ENTER
UNIT Data are displayed ......................................................................... press ENTER
Select COMPONENT TEST from the MAIN MENU ....................... press ENTER
Select CASSETTE MOTORS ................................................................. press ENTER
Select CASSETTE TRANSPORT M2 ................................................... press ENTER
2
. Check that the MOTOR is running forward/backward.
Select FORWARD/BACKWARD
3
. Exit the SERVICE PROGRAM
Press BACKSPACE 3 times
Select LEAVE COMPONENT TEST .................................................... press ENTER
Select QUIT ML2000 SERVICE MODE ............................................. press ENTER
Select Quit the program ........................................................................... press ENTER
4
. Ensure that all PANELS are mounted correctly and that all PROTECTIVE GROUND
CABLES are properly connected.
KODAK AG, Stuttgart
NOTE
THE DOWEL PIN MAY FALL DOWN.
NOTE
2-11
REPLACEMENTS
6/97