Kodak Miniloader 2000 Service Manual page 39

SM 3477
10.
Disconnect the GROUND WIRE at the ROLLER MOTOR.
11.
Disconnect the CONNECTORS of both CARRIAGE POSITION SENSORS.
12.
Disconnect the CONNECTOR of the SENSOR VACUUM OFF (B20).
13.
Carefully lift out the CARRIAGE ASSEMBLY.
Do not lose the SPACER of the PRESSURE ROLLER SHAFT located on the ROLLER MOTOR
KODAK AG, Stuttgart
figure 2-26
figure 2-27
NOTE
side.
2-29
REPLACEMENTS
6/97