Kodak Miniloader 2000 Service Manual page 67

SM 3477
27.
Manually rotate the SUCKER BAR ARM fully down, until the BALL BEARING is
fully engaged in the LOWER DETENT.
28.
Open the SET SCREW of the right hand TIMING DISK.
29.
Turn the SUCKER BAR backward by hand until there is no clearance.
30.
Rotate the right hand TIMING DISK in the direction of the arrow until SENSOR
B58/M_PU_ER is interrupted. This is indicated by a BEEP from the SENSOR TEST.
31.
Tighten the SET SCREW.
32.
Check that the FILM POCKET SUCKER BAR reaches the REAR POSITION without
bouncing.
KODAK AG, Stuttgart
figure 3-22
figure 3-23
3-21
ADJUSTMENTS
6/97