Replacement Of Cassette Input Flap Motor M1 - Kodak Miniloader 2000 Service Manual

SM 3477

REPLACEMENT OF CASSETTE INPUT FLAP MOTOR M1.

1
. Switch off the ML2000 (ML2000 P).
2
. Take off the SIDE PANELS.
3
. Take off the FRONT PANEL with DISPLAY.
The CABLE to the DISPLAY is short. Disconnect it when the FRONT PANEL is off. The PROTEC-
TIVE GROUND WIRE from the DISPLAY is short too. It is connected to the GROUND TERMINAL
4
. Manually turn the INPUT FLAP MOTOR CAM to fully lower the INPUT FLAP. This
gives access to the 3 MOTOR MOUNTING SCREWS.
5
. Take off the INPUT FLAP CAM.
Take care when removing the CAM. There is a DOWEL PIN behind it.
6
. Take out the 3 MOUNTING SCREWS of the INPUT FLAP MOTOR.
7
. Install the new MOTOR.
8
. Install the FRONT PANEL. Ensure that the CABLE to the DISPLAY and the
PROTECTIVE GROUND WIRE is connected properly.
KODAK AG, Stuttgart
CAUTION
CLOSE TO MOTOR M1. Disconnect it too.
figure 2-4
NOTE
2-3
REPLACEMENTS
6/97