Kodak Miniloader 2000 Service Manual page 71

SM 3477
45.
Press Backspace until you reach the screen COMPONENT TEST.
46
. Switch off the SOLENOID TILTING MAGAZINE SUCKER BAR Y14 to avoid
overheating and let it cool down if necessary .
Press BACKSPACE 3 times
Select SOLENOIDS ................................................................................... press ENTER
Select TILTING MAGAZINE SUCKER BAR Y14 ............................. press ENTER
Select SOLENOID OFF
Press BACKSPACE twice to go back to the screen COMPONENT TEST
47.
Manually rotate the SUCKER BAR fully out.
48.
Move the FILM POCKET to MAGAZINE LEVEL 2.
Select MAGAZINE MOTORS................................................................. press ENTER
Select STEPPER MOTOR FILM POCKET M10 ................................ press ENTER
Select MOVE TO LEVELS/HOME POSITION .................................. press ENTER
Select MOVE TO MAGAZINE 3
49
Go back to step 35, to verify correct setup of SUCKERS in Mag. Level 2.
50.
Switch off the SOLENOID TILTING MAGAZINE SUCKER BAR Y14 to avoid
overheating and let it cool down if necessary .
Press BACKSPACE 3 times
Select SOLENOIDS ................................................................................... press ENTER
Select TILTING MAGAZINE SUCKER BAR Y14 ............................. press ENTER
Select SOLENOID OFF
51.
Check that the BLOW PIPES are not touching the side of the MAGAZINE
RECESSES. The BLOWPIPES must not be in the recess areas shaded grey.
52.
If they are too far to the left or to the right, loosen SCREW 1 and carefully move
the SUCKER BAR ARM in the desired direction. Make sure the SUCKER Bar does not
interfere with the DOUBLE FILM DETECTOR. See figure 3-29 on the next page.
If the SUCKER BAR ARM is too far to the left, SCREW 2 from the COLLAR has also to be
KODAK AG, Stuttgart
figure 3-28
NOTE
loosened.
3-25
ADJUSTMENTS
6/97