Kodak Miniloader 2000 Service Manual page 23

SM 3477
13.
Loosen the MOUNTING SCREWS of CASSETTE TRANSPORT MOTOR M2.
14.
Take off the DRIVE PULLEY and the DRIVE BELT.
15.
Move out the MOUNTING PLATE. This gives access to the CASSETTE OPENER
MOTOR.
16.
Take out the CASSETTE OPENER MOTOR.
The MOTOR comes off with a THREAD PLATE. This THREAD PLATE must be inserted again with
17.
Insert the new CASSETTE OPENER MOTOR together with the THREAD PLATE. Fix
it with 3 MOUNTING SCREWS. Mount SENSOR B15 at this time.
18.
Mount the MOUNTING PLATE. Use the 2 SCREWS removed in step 10.
19.
Mount the OPENER STOP PLATE. Use the marks made in step 5 as reference.
Tighten the MOUNTING SCREWS just a bit, that the STOP PLATE can still be moved.
20.
Mount the DRIVE PULLEY and the DRIVE BELT of the CASSETTE TRANSPORT
MOTOR. Tension the DRIVE BELT and fasten the MOUNTING SCREWS of MOTOR M2.
21.
Switch on the ML2000 (ML2000 P)
BE CAREFUL WHEN WORKING IN THE CASSETTE OPENER AREA. THE OPENER MOTOR AND
THE OPENER MECHANISM ARE VERY STRONG. THEY CANNOT BE MOVED MANUALLY. THEY
MAY SQUEEZE YOUR HAND AND TRAP YOU IF YOU TRY TO STOP THEM MANUALLY. NEVER
START THE CASSETTE OPENER MOTOR WHEN SOMEONE'S HANDS ARE IN THE CASSETTE
22.
To mount the MOTOR DRIVE GEAR the DOWEL PIN has to be in the correct
position in relation to the STOP BOLTS of the STOP PLATE. To rotate the MOTOR
SHAFT use the SERVICE PROGRAM. Switch on the CASSETTE OPENER MOTOR M5
until the DOWEL PIN is in a horizontal position. See the drawing on the next page.
Select SERVICE MODE from the GLOBAL MENU ......................... press ENTER
ENTER SERVICE MODE MESSAGE is displayed .......................... press ENTER
UNIT DATA are displayed ..................................................................... press ENTER
Select COMPONENT TEST from the MAIN MENU press ENTER
Select CASSETTE MOTORS ................................................................. press ENTER
Select CASSETTE OPENING M5 ......................................................... press ENTER
Select DOWN or UP until the DOWEL PIN is in a horizontal position.
KODAK AG, Stuttgart
There is a DOWEL PIN behind the SMALL DRIVE GEAR.
There is a DOWEL PIN behind the DRIVE PULLEY.
the new MOTOR. It holds the OPENER STOP PLATE.
NOTE
NOTE
NOTE
WARNING
AREA.
2-13
REPLACEMENTS
6/97