Removal Of The Receiving Magazine Tunnel(Ml2000 Only) - Kodak Miniloader 2000 Service Manual

SM 3477

REMOVAL OF THE RECEIVING MAGAZINE TUNNEL(ML2000 only)

PURPOSE:
The RECEIVING MAGAZINE TUNNEL has to be removed if one of the following SENSORS
has to be replaced or adjusted, or if the MAIN SWITCH has to be replaced.:
B24/C_RM_E RECEIVING MAGAZINE ENTRANCE
B25/C_RM_F RECEIVING MAGAZINE FULL
B34/C_RM_C RECEIVING MAGAZINE CODE.
1
. Switch off the ML2000 (ML2000 P).
2
. Take off the PANELS.
3
. Take out the 4 MOUNTING SCREWS.
4
. Carefully pull out the RECEIVING MAGAZINE TUNNEL and disconnect the SENSORS.
To adjust the SENSORS an EXTENSION CABLE is required. This EXTENSION CABLE is sent out
with the ML2000 and it is stored in the PNEUMATIC AREA.
KODAK AG, Stuttgart
figure 2-21
NOTE
2-25
REPLACEMENTS
6/97