OPERATOR MANUAL
[4] Repeat Steps 2 and 3 until the film exits "just dry."
Film Feeding Procedure
Feeding Sheet Films:
Caution
• Do not pull back films after you begin to feed them into the processor.
• Feed all sheet films except 10 x 10 cm (4 x 4 in.) sheets square with the left edge of the Film Guide.
Feed 10 x 10 cm (4 x 4 in.) sheets square with the right edge of the Film Guide. See Figure 15 on
Page 23 for the recommended film feeding procedure. The arrows indicate the direction in which
you should feed the films into the processor for optimum replenishment.
• Feed the next sheet of film after you hear the film-feed signal and the Wait Indicator turns off. The
film-feed signal alerts you that the trailing edge of the sheet of film has left the Film Sensors and
is fully into the processor. At this point, you may either feed another sheet of film, or turn on the
room lights.
• Feed single-emulsion films with the emulsion-side up.
22
September 1995 – 981089