Kodak Miniloader 2000 Service Manual page 68

ADJUSTMENTS
Press BACKSPACE twice to come back to the screen COMPONENT TEST
Select MAGAZINE MOTORS................................................................. press ENTER
Select FILM PICK UP MAGAZINE M15 ............................................ press ENTER
Select FORWARD
Select BACKWARD
33.
Run a few cycles; if the FILM does not interfere with parts of the CASSETTE
TRANSPORT MODULE,proceed with step 34, else go back to step 27.
34.
Move the FILM POCKET to MAGAZINE LEVEL 3
Start the SERVICE PROGRAM
Select SERVICE MODE from the GLOBAL MENU .......................... press ENTER
ENTER SERVICE MODE MESSAGE is displayed ............................ press ENTER
UNIT DATA are displayed....................................................................... press ENTER
Select COMPONENT TEST from the MAIN MENU ........................ press ENTER
Select MAGAZINE MOTORS................................................................. press ENTER
Select STEPPER MOTOR FILM POCKET M10 ................................ press ENTER
Select MOVE TO LEVELS/HOME POSITION .................................. press ENTER
Select MOVE TO MAGAZINE 3
35.
After the FILM POCKET has reached LEVEL 2, rotate the FILM POCKET SUCKER
BAR to its vertical position,so that the BALL BEARING is fully engaged in the DETENT.
Press BACKSPACE twice to come back to the screen COMPONENT TEST
Select MAGAZINE MOTORS................................................................. press ENTER
Select FILM PICK UP MAGAZINE M15 ............................................ press ENTER
Select FORWARD
36.
Check that the CABLE PROTECTING BRACKET AT SENSOR B61 FILM AT
SUCKER BAR is not bent. Otherwise the BRACKET will ride on the MAGAZINE WALL
and the SUCKERS do not reach the FILMS in the MAGAZINE.
37.
Move the FILM Pocket to the FILM in the MAGAZINE with the FILM POCKET
SUCKER BAR tilted.
Press BACKSPACE twice to go back to the SCREEN COMPONENT TEST.
Select SOLENOIDS ................................................................................... press ENTER
Select TILTING MAGAZINE SUCKER BAR Y14 ............................. press ENTER
Press BACKSPACE twice to go back to the SCREEN COMPONENT TEST.
Select MAGAZINE MOTORS ............................................................... press ENTER.
Select STEPPER MOTOR FILM POCKET M10 ............................... press ENTER.
Select MOVE TO A SPECIAL POSITION .......................................... press ENTER.
Select POCKET TO FILM (MAG)
Do not energise the SOLENOID Y14 for too long. It will become very hot.
38.
Check that all SUCKERS are parallel on the FILM.
6/97
NOTE
3-22
SM 3477
KODAK AG, Stuttgart