Kodak Miniloader 2000 Service Manual page 65

SM 3477
Select STEPPER MOTOR FILM POCKET M10 ................................ press ENTER
Select MOVE TO LEVELS/HOME POSITION .................................. press ENTER
Select MOVE TO MAGAZINE 2
13.
Rotate the FILM POCKET SUCKER BAR ARM to its vertical position, so that the
BALL BEARING is fully engaged in the DETENT.
Press BACKSPACE twice to come back to the screen TEST MAGAZINE MOTORS
Select FILM PICK UP MAGAZINE M15 ............................................ press ENTER
Select FORWARD
14.
Move the SUCKER BAR by hand using low force. If it can be moved proceed with
step 15 else proceed with step 23.
15.
Start the SENSOR TEST.
Press BACKSPACE twice to go back to the screen COMPONENT TEST
Select SENSORS......................................................................................... press ENTER
Select SENSOR TEST WITH SOUND.................................................. press ENTER
16.
Make sure that the BALL BEARING is still engaged in the DETENT.
17.
Loosen the SET SCREW of the LEFT TIMING DISK.
18.
Push the SUCKER BAR forward by hand until there is no clearance.
KODAK AG, Stuttgart
figure 3-20
3-19
ADJUSTMENTS
6/97