Table of Contents
Advertisement
REPLACEMENTS
8
.
Remove the SCREWS from each of the RETAINERS on each side of the
CONVEYOR.
9
.
Lift out the CONVEYOR.
DISASSEMBLY OF THE CONVEYOR
Disassembly of the CONVEYOR is needed for removing the following:
DRIVE SHAFTS
CARRIAGE ASSEMBLY
DRIVE BELTS
1
.
Do PROCEDURE "REMOVAL OF CONVEYOR".
2
.
Cut the WIRE TIES along the upper TIE RODS. Mark the position of the WIRE TIES.
See figure 2-26 on the next page
3
.
Take out the 4 NUTS at the TIE RODS.
4
.
Remove the 12 C-RINGS from the upper 2 TIE RODS.
5
.
Remove the CARRIAGE STOP.
6
.
Slide out both upper TIE RODS.
7
.
Take out C-RINGS at both PRESSURE ROLLER SHAFTS and slide SHAFTS
outwards. See figure 2-27 on the next page.
8
.
Take out SPRINGS.
.
9
Disconnect the VACUUM SOLENOID CONNECTOR.
6/97
figure 2-25
2-28
SM 3477
KODAK AG, Stuttgart
Advertisement
Chapters
Table of Contents
