Kodak Miniloader 2000 Service Manual page 72

ADJUSTMENTS
Ensure that the position of the MAGAZINE SUCKER BAR in relation to the 3 mm reference line is
SCREW 1
53.
Tighten SCREW 1
It is most important that SCREW 1 is tightened. If it is not tight, the relationship between the 2
FILM POCKET TIMING DISKS and the MAGAZINE SUCKER BAR will be lost. It is then impossible
54.
Move the COLLAR with SCREW 2 to the left as far as possible and tighten
SCREW 2.
55.
Check that the BLOW PIPES are correct in the MAGAZINE RECESSES. The
BLOWPIPES must not be in the shaded areas. They have to be between the centreline
of the recess and the MAGAZINE WALL. They must not touch the MAGAZINE WALLS.
If this distance is not correct, loosen the LENGTH ADJUSTMENT SCREWS of the
BLOWPIPES and shift them forward or backward. Tighten the screws. See the figure
on the next page.
Do not tighten the LENGTH ADJUSTMENT SCREWS too much, otherwise they dig into the BLOW-
6/97
not changed (see step 40).
figure 3-29
to pick up a film from the MAGAZINE.
PIPES and a fine adjustment is no longer possible.
NOTE
SCREW 2
Note
NOTE
3-26
SM 3477
KODAK AG, Stuttgart