Kodak Miniloader 2000 Service Manual page 55

SM 3477
8
. Exit the SERVICE MODE.
Press BACKSPACE 3 times
Select LEAVE COMPONENT TEST ..................................................... press ENTER
Select Quit ML2000 (ML2000 P) SERVICE MODE ........................ press ENTER
Select Quit the program ............................................................................ press ENTER
FUNCTION TEST
1
. Enable the CONTINUOS LOOP MODE.
Move SWITCH S1-1 on PCB A1 to the ON (up) position.
Select FUN at the OPERATORS DISPLAY
Select SYSTEM at the OPERATORS DISPLAY
Select CONTAIN at the OPERATORS DISPLAY
Select CLEAR at the OPERATORS DISPLAY
The ML2000 (ML2000 P) is now set to the CONTINUOUS LOOP MODE. This means after a
loaded CASSETTE is fed in, this CASSETTE becomes unloaded and loaded repeatedly.
2
. Feed in a loaded CASSETTE 18x24 cm.
3
. Observe from the side that the trailing edge of the FILM just touches the CASSETTE
SUCKERS (look at the middle of the SUCKER BAR ), when the FILM is transported into
the CONVEYOR.
KODAK AG, Stuttgart
figure 3-11
3-9
ADJUSTMENTS
6/97