Replacement Of Film Pocket Spring - Kodak Miniloader 2000 Service Manual

REPLACEMENTS
3
. Exit the SERVICE PROGRAM
Press BACKSPACE 3 times
Select LEAVE COMPONENT TEST ..................................................... press ENTER
Select QUIT ML2000 SERVICE MODE ............................................... press ENTER
Select Quit the program ........................................................................... press ENTER

REPLACEMENT OF FILM POCKET SPRING.

AFTER THE TORSION SPRING IS REPLACED NO ADJUSTMENT is required.
1
. Switch off the ML2000 (ML2000 P).
2
. Take off the PANELS.
3
. Take out the FILM CHUTE.
4
. Loosen the COLLAR. This allows to shift the right-hand CLUTCH DISK a bit to the
right.
5
. Replace the old SPRING with a new one.
6
. Move the COLLAR to the left and tighten it.
FUNCTION TEST.
1
. Check that small and large FILMS are picked up correctly from the magazines.
6/97
NOTE
figure 2-18
2-22
SM 3477
KODAK AG, Stuttgart