Main Drive; Removing The Drive Shaft, Drive Chain, Drive Motor, Worm Gears, And Drive Shaft Bearings - Kodak X-Omat 3000 RA Manual

ADJUSTMENTS AND REPLACEMENTS
Section 3: MAIN DRIVE
Removing the DRIVE SHAFT, DRIVE CHAIN, DRIVE MOTOR, WORM
GEARS, and DRIVE SHAFT BEARINGS
DRIVE CHAIN
COVER
Note
It is not necessary to remove the DRIVE MOTOR to remove the DRIVE SHAFT.
Warning
Dangerous voltage.
[1] De-energize the PROCESSOR.
[2] Remove:
• DRIVE CHAIN COVER
• DRIVE CHAIN
• DRIVE MOTOR (if necessary)
[3] Remove from the FEED END of the DRIVE SHAFT:
• E-RING
• DRIVE SHAFT WASHER (quantity may vary)
• BEARING RETAINER and BEARING (if necessary)
14
DRIVE
CHAIN
LOCK
WASHER
SPROCKET
MOUNTING
NUT (4)
GEAR
BOX
WASHER
CONNECTOR
P/J 22
MOTOR
BRACKET
DRIVE
MOTOR
DRIVE
BOLT (4)
MOTOR
CABLE
SHIELD
CONNECTOR
H104_0412HCB
H104_0412HA
28JAN98 – 7C8285