Kodak Miniloader 2000 Service Manual page 24

REPLACEMENTS
23.
Mount the DRIVE GEAR onto the MOTOR SHAFT. Ensure that it is seated properly
on the DOWEL PIN. Mount the ACTUATOR removed in step 3 to hold the DRIVE GEAR
on the SHAFT. Do not tighten the ACTUATOR SCREW at this time.
The STOP PIN of the DRIVE GEAR has to be to the left of the bottom STOP BOLT. If it is to the
right the CASSETTE OPENER cannot move the full distance.
6/97
figure 2-11
NOTE
figure 2-12
2-14
SM 3477
KODAK AG, Stuttgart