Drive Belt Tension - Kodak Miniloader 2000 Service Manual

ADJUSTMENTS
5
. Set the JUMPER of A8X50 to the MIDDLE POSITION (pin 2-5). This is the position
for normal operation.
6
. Exit the the SERVICE PROGRAM.
Press BACKSPACE 3 times
Select LEAVE COMPONENT TEST ..................................................... press ENTER
Select QUIT ML2000 SERVICE MODE ............................................... press ENTER
Select Quit the program ............................................................................ press ENTER
7
. Run several cycles with all types of CUSTOMER FILMS to ensure correct operation.

DRIVE BELT TENSION

Purpose:
This adjustment ensures that the CASSETTE is correctly transported in and out.
1
. Move the BELT TENSIONERS up or down, to tension the DRIVE BELT.
There is no fixed value for the DRIVE BELT tension. The tension of the DRIVE BELT is not critical.
6/97
NOTE
1
figure 3-15
3-14
SM 3477
KODAK AG, Stuttgart