Replacement Of The Short Transport Roller - Kodak Miniloader 2000 Service Manual

SM 3477
4
. Loosen the BELT TENSIONERS and take off the DRIVE BELT. This allows the
FRONT TRANSPORT ROLLER to turn and bring the DOWEL PINS to a horizontal
position. This prevents them from coming lost.
5
. Take off the C-RING and the SPACER at the DRIVE PULLEY.
6
. Carefully pull the DRIVE PULLEY off the SHAFT.
There is a DOWEL PIN behind the DRIVE PULLEY. If it is not in a horizontal position, it may fall
down and becomes lost. Therefore turn the FRONT TRANSPORT ROLLER if necessary.
7
. Take out DOWEL PIN, SPACER and BEARING.
8
. Take off the C-RING from the DRIVE GEAR on the right-hand side.
9
. Take off the CAP and the DOWEL PIN underneath.
10.
Shift the FRONT TRANSPORT ROLLER fully to the left and take off the DRIVE
GEAR.
11.
Take out the BEARING.
12.
Take out the FRONT TRANSPORT ROLLER and replace it with a new one.
FUNCTION TEST.
1
. Check that a CASSETTE is transported correctly forward and backward.
2
. Ensure that all PANELS are mounted correctly and that all PROTECTIVE GROUND
CABLES are properly connected.

REPLACEMENT OF THE SHORT TRANSPORT ROLLER

1
. Switch off ML2000 (ML2000 P).
2
. Take off the PANELS.
3
. Loosen the BELT TENSIONERS and take off the DRIVE BELT.
4
. Take off the C-RING and SPACER at the DRIVE PULLEY.
5
. Take off the DRIVE PULLEY.
There is a DOWEL PIN behind the DRIVE PULLEY. If it is not in a horizontal position, it may fall
down and becomes lost. Therefore turn the FRONT TRANSPORT ROLLER if necessary.
6
. Take out the DOWEL PIN, SPACER and the BEARING.
7
. Take off the right-hand C-RING of the SHORT TRANSPORT ROLLER.
8
. Take out the BEARING.
9
. Replace the SHORT TRANSPORT ROLLER with a new one.
FUNCTION TEST.
1
. Check that a CASSETTE is transported correctly forward and backward.
KODAK AG, Stuttgart
NOTE
NOTE
For details see the drawing on the next page.
NOTE
2-7
REPLACEMENTS
6/97