Kodak Miniloader 2000 Service Manual page 78

ADJUSTMENTS
77.
Check that the BLOW PIPES have the correct distance of 0-1 mm to the wall of
MAGAZINE 1.
Select STEPPER MOTOR FILM POCKET M10 ................................ press ENTER
Select MOVE TO LEVELS/HOME POSITION ................................. press ENTER
Select Move to MAGAZINE 1 START
Press BACKSPACE twice to come back to screen TEST MAGAZINE MOTORS
Select FILM PICK UP MAGAZINE M15 ............................................ press ENTER
Select FORWARD
78.
If the distance is not correct, go back to step 70 and alter the MAGAZINE LEVEL
ADJUSTMENT.
79.
Rotate out the FILM POCKET SUCKER BAR.
Select BACKWARD
.
80
Exit the SERVICE PROGRAM.
Press BACKSPACE 3 times
Select LEAVE COMPONENT TEST ..................................................... press ENTER
Select QUIT ML2000 SERVICE MODE ............................................ press ENTER
Select Quit the program ............................................................................ press ENTER
81.
Run several cycles.
82.
Make sure that the MAGAZINE BLOW PIPES do not interfere with the CASSETTES.
83.
If the distance is not as shown in the figure on the previous page, loosen the
MOUNTING SCREWS of the CASSETTE LEVEL BRACKET and move it up or down as
required. Then fasten the MOUNTING SCREWS.
84.
Do a SCAN RUN.
Press BACKSPACE 3 times
Select LEAVE COMPONENT TEST ..................................................... press ENTER
Select CHANGE ML2000 DATA ............................................................ press ENTER
6/97
Find a compromise between MAGAZINE LEVEL 1 and 2.
NOTE
figure 3-36
3-32
SM 3477
KODAK AG, Stuttgart