Replacement Of The Front Soft Roller Shaft Assy - Kodak Miniloader 2000 Service Manual

REPLACEMENTS
FUNCTION TEST
1
. Start the CASSETTE INPUT FLAP MOTOR M1
Start the SERVICE PROGRAM.
Select SERVICE MODE from the GLOBAL MENU ......................... press ENTER
ENTER SERVICE MODE MESSAGE is displayed ............................ press ENTER
UNIT DATA are displayed ..................................................................... press ENTER
Select COMPONENT TEST from the MAIN MENU ....................... press ENTER
Select CASSETTE MOTORS ................................................................. press ENTER
Select INPUT FLAP MOT M1 .............................................................. press ENTER
Select CLOSE/OPEN ................................................................................ press ENTER
2
. Make sure that the MOTOR CAM turns clockwise. If it turns counter-clockwise
interchange PIN 1 and 3 at the MOTOR CONNECTOR.
3
. Exit the SERVICE PROGRAM
Press BACKSPACE 3 times.
Select LEAVE COMPONENT TEST .................................................... press ENTER
Select QUIT ML2000 SERVICE MODE ............................................... press ENTER
Select Quit the program ............................................................................ press ENTER

REPLACEMENT OF THE FRONT SOFT ROLLER SHAFT ASSY.

1
. Switch off ML2000 (ML2000 P).
2
. Take off the PANELS.
3
. Take out the INPUT FLAP MOTOR M1 and the INPUT PANEL. This gives better
access to the SOFT ROLLER SHAFT.
4
. Loosen the BELT TENSIONERS and take off the DRIVE BELT. See the drawing on
the next page.
5
. Take off the C-RING at the DRIVE PULLEY.
6
. Take off the CAP.
Take care when removing the CAP. There is a DOWEL PIN underneath. Removing the DRIVE
BELT in step 4 allows to turn the SOFT ROLLER SHAFT ASSY until the DOWEL PIN is in a hori-
7
. Take out the DOWEL PIN.
8
. Take off the DRIVE GEAR.
9
. Take out the WASHER and the C-RING on the left-hand side of the SOFT ROLLER
SHAFT ASSY. Remove the SOFT ROLLER SHAFT ASSY.
10
. Install the new SOFT ROLLER SHAFT ASSY.
FUNCTION TEST
1
. Check that a CASSETTE is transported correctly forward and backward.
2
. Ensure that all PANELS are mounted correctly and that all PROTECTIVE GROUND
CABLES are properly connected.
6/97
NOTE
zontal position.
2-4
SM 3477
KODAK AG, Stuttgart