Kodak Miniloader 2000 Service Manual page 75

SM 3477
Select MAGAZINE SUCKING Y12 ...................................................... press ENTER
Select SOL. VALVE OFF
Press BACKSPACE
Select MAGAZINE BLOW SUCKER Y10 .......................................... press ENTER
Select SOL. VALVE ON
Select SOL. VALVE OFF
Press BACKSPACE twice to come back to the screen COMPONENT TEST
Select MAGAZINE MOTORS ............................................................... press ENTER
Select COMPRESSOR M16 .................................................................... Press ENTER
Select MOTOR OFF
63.
To do the adjustment of the SENSOR B61, place the BLOW PIPE POSITION TOOL
TL-4582 onto the MAGAZINE SUCKERS and start the SENSOR TEST.
Press BACKSPACE twice to come back to the screen COMPONENT TEST
Select SENSORS ....................................................................................... press ENTER
Select SENSOR TEST WITH SOUND ................................................ press ENTER
64.
Carefully press down the tool onto the SUCKERS. After 0.2 - 0.5 mm, SENSOR B61
should be actuated.
65.
If the SENSOR is not actuated, carefully bend the ACTUATOR BRACKET.
66.
Exit the SENSOR TEST.
Press BACKSPACE twice to come back to the screen COMPONENT TEST
67.
Insert an empty MAGAZINE into position 2.
68.
Check that there is a gap of 0 to 1 mm between the BLOW PIPES and the
MAGAZINE WALL.
Select MAGAZINE MOTORS ............................................................... press ENTER
Select STEPPER MOTOR FILM POCKET M10 ............................... press ENTER
Select MOVE TO LEVELS/HOME POSITION ................................. press ENTER
Select Move to MAGAZINE 3 START
Press BACKSPACE twice to come back to screen TEST MAGAZINE MOTORS
KODAK AG, Stuttgart
CAREFULLY BEND HERE. BUT ONLY IF NECESSARY!
Both ACTUATORS must touch the tool at the same time.
figure 3-33
3-29
ADJUSTMENTS
6/97