Kodak Miniloader 2000 Service Manual page 50

ADJUSTMENTS
6
. Adjust the ACTUATOR of SENSOR B15/C_OP_EO CASSETTE OPENER END
SWITCH OPEN as required.
7
. Move the CASSETTE OPENER fully down.
Select DOWN
Proceed with step 4.
8
. Fasten the ACTUATOR MOUNTING SCREW.
9
. With the OPENER still in the upper position, turn the STOP PLATE counter-clockwise
until the STOP BOLT touches the STOP PIN of the DRIVE GEAR. Turn the STOP
PLATE clockwise until there is a gap of approximately 1 mm between the STOP PIN
and the STOP BOLT.
It is not possible to see the gap of 1 mm. You have to set it by feeling._
10.
Tighten the MOUNTING SCREWS of the STOP PLATE.
11.
Check the position of the STOP PLATE.
-Disconnect SENSOR B15(CONNECTOR X9)
-Select UP. The MOTOR M5 must turn for a short distance and is stopped then
( A high pitched tone can be heard at the same time.)
-Connect SENSOR B15.
-Select DOWN until the CASSETTE OPEN_ER stops in its bottom position.
-Manually actuate SENSOR B15. Do not break its thin PLASTIC ACTUATOR.
-Select DOWN again. MOTOR M5 should turn for a short distance and is
stopped then. A high pitched tone can be heard at the same time.
-Select UP until the CASSETTE OPENER stops in its uppermost position.
If the UP and DOWN positions are correct proceed with step 12. Otherwise reposition
the STOP PLATE and repeat step 11.
6/97
NOTE
figure 3-4
3-4
SM 3477
KODAK AG, Stuttgart