Film Pocket; Replacement Of The Film Pocket Stepper Motor M10 - Kodak Miniloader 2000 Service Manual

SM 3477
10.
Install all parts and connect all SENSORS.
11.
Check the function and the adjustment of SENSORS B36 and B37.
Start the SERVICE PROGRAM
Select SERVICE MODE from the GLOBAL MENU .......................... press ENTER
ENTER SERVICE MODE MESSAGE is displayed ............................ press ENTER
UNIT DATA are displayed....................................................................... press ENTER
Select COMPONENT TEST from the MAIN MENU ........................ press ENTER
Select MAGAZINE MOTORS................................................................. press ENTER
Select MAGAZINE OPENING M14...................................................... press ENTER
Select FORWARD / BACKWARD
To avoid fogging of customer films, load the MAGAZINES with test films.
12.
Check that the MAGAZINE OPENER goes fully down. If necessary adjust the
position of SENSOR B37.
13.
Ensure that the MAGAZINES are fully opened. The MAGAZINE LIDS must not touch
the above MAGAZINE GUIDES. If necessary adjust the position of SENSOR B36.
14.
Exit the SERVICE MODE.
Press BACKSPACE 3 times
Select LEAVE COMPONENT TEST ..................................................... press ENTER
Select QUIT ML2000 SERVICE MODE ............................................... press ENTER
Select Quit the program ............................................................................ press ENTER
FUNCTION TEST.
No special FUNCTION TEST is necessary. The function of MOTOR M14 was tested during
the adjustments. Ensure that all PROTECTIVE GROUND WIRES are mounted correctly.

FILM POCKET

REPLACEMENT OF THE FILM POCKET STEPPER MOTOR M10.

1
. Switch off the ML2000 (ML2000 P).
2
. Take off the PANELS.
3
. Take out the FILM CHUTE (ML2000 only)
4
. Take out the PROTECTIVE GUARD. See the drawing on the next page.
5
. Loosen the STEPPER MOTOR MOUNTING SCREWS.
6
. Take off MOTOR SPROCKET and CHAIN.
7
. Take out the STEPPER MOTOR MOUNTING SCREWS.
8
. Install new the STEPPER MOTOR.
9
. Move the STEPPER MOTOR up to tension the CHAIN.
KODAK AG, Stuttgart
NOTE
NOTE
Take care of the DOWEL PIN it may fall down.
2-19
REPLACEMENTS
6/97