Temperature Reading - Operating Mode For Fault; Temperature Reading - Control Value For Fault (0 - 255) - ABB ClimaECO SBS/Ux.0.1 Series Product Manual

11.4.16 Temperature reading — Operating mode for fault
Options:
In the event of a failure of the actual temperature measurement, the device will no longer be
able to independently specify the heating/cooling operating type. As a result, the operating type
best suited to protecting the building will be selected.
Note
This parameter is only available when the "Control function" parameter is set on
"Heating and cooling" or "heating and cooling with additional stages".
11.4.17 Temperature reading — Control value for fault (0 - 255)
Options:
In the event of a failure of the actual temperature measurement, the device will no longer be
able to independently determine the control value. In case of an error, a PWM control (1 Bit)
with a fixed cycle time of 15 minutes is used automatically instead of a parameterized 2-point
control (1 Bit). In this case the set parameter value is taken into consideration for the control
value during an error.
Product manual 2CKA001473B9679
Description of application and parameters
Cooling
Heating
Setting option between 0 - 255
Application "RTC"
│133