Table of Contents
Advertisement
12.1.28 RTC - Presence detector
Name
RTC: Presence detector
RTC: Presence detector
(Master/Slave)
The signal of a movement detector is received via the 1-bit communication object. If a person is
present in the room, a telegram with value "1" is sent to the RTC.
If no other communication object with a higher priority is active, the RTC is set on the comfort
setpoint value by the message "Person present in the room".
In addition to manual setpoint adjustment and the adjustment of the basic setpoint value, the
setpoint temperature of the controller is defined by the following communication objects: (listed
in decreasing order of priority).
"RTC: Override operating mode"
■
"RTC: Condensate water alarm"
■
"RTC: Dew point alarm"
■
"RTC: Window contact"
■
"RTC: Control On/Off"
■
"RTC: Presence detector"
■
"RTC: Normal operating mode"
■
Notice
When the master/slave operation is activated, the object "RTC: Presence
detector (master/slave) of the master and slave device must be connected with
the group address of the sending device.
12.1.29 RTC - Heating status
Name
RTC: Heating status
An On telegram is sent on the bus via the 1-bit communication object as soon as the RTC is in
active heating mode.
If the controller is in cooling mode or in the inactive zone between heating and cooling, the RTC
sends an OFF telegram via the "RTC: Heating status" object.
12.1.30 RTC - Cooling status
Name
RTC: Cooling status
An On telegram is sent on the bus via the 1-bit communication object as soon as the RTC is in
active cooling mode.
If the controller is in heating mode or in the inactive zone between heating and cooling, the RTC
sends an OFF telegram via the "RTC: Cooling status" object.
Product manual 2CKA001473B9679
Object function
Input
Input
Object function
Output
Object function
Output
Communication objects
Communication objects
Data type
1.001 Switching
1.001 Switching
Data type
1.001 Switching
Data type
1.001 Switching
│343
Advertisement
Table of Contents
