6.5.3
Surface-mounted installation
6.5.3.1
Mounting with surface-mounted mounting frame
Notice
Surface-mounted housings/frames are not included in the scope of delivery and
must be purchased separately!
Preparatory work:
For the installation on a surface-mounted frame, the fastening screw must be made accessible
on the operating section on the front of the device.
–
Pull off the bottom end strip.
–
Remove the cover of the labelling field.
For additional information, please see chapter "Labelling inlay"
Unscrew the flush-mounted insert of the device
Fig. 23:
Preparing the operating section
1. Pull off the KNX terminal [2]
2. Screw out the screws (Torx T8 [1]
3. Remove the flush-mounted insert [3]
Product manual 2CKA001473B9679
3
2
1
Connection, installation / mounting
│43