Rh - Relative Humidity Value; Rh - Relative External Humidity Value; Rh - Request Humidity Value; Rh - Sensor Error - ABB ClimaECO SBS/Ux.0.1 Series Product Manual

12.1.82 RH - Relative humidity value

Name
RH: Relative humidity value
The humidity value measured by the device is available via the communication object.

12.1.83 RH - Relative external humidity value

Name
RH: Relative external humidity
value
If another humidity value is to be included in the measurement, this input can be linked with the
other output of a corresponding device.
12.1.84 RH – Request humidity value
Name
RH: Request humidity value
If the external value is not to be sent cyclically or if the device is being reset, the external value
is requested via this object.
12.1.85 RH – Sensor error
Name
RH: Sensor error
If a sensor defect occurs or no current value is available to the KNX bus, a telegram with the
value "1" is sent to the KNX bus.
A telegram with the value "0" resets the error.

12.1.86 RH - Control value

Name
RH: Control value
The humidity controller sends its control value to an actuator via the control value
communication object when the controller type is set on PI controller.
Product manual 2CKA001473B9679
Object function
Output
Object function
Input
Object function
Input
Object function
Output
Object function
Output
Communication objects
Communication objects
Data type
9.* 2-byte floating point value
Data type
9.* 2-byte floating point value
Data type
1.017 Trigger
Data type
1.001 Switching
Data type
5.001 Percent
(0..100%)
│360