11.6.28 Step controller — Switch command above threshold 2
Options:
The parameter defines which state should be sent after threshold value 2 is exceeded.
Notice
The parameter is available only when parameter "Control value output format" is
set on "Switching command".
Notice
The parameter is available only when parameter "Controller type" is set on
"Two-stage" or "Three-stage".
11.6.29 Step controller— Priority above threshold 2
Options:
The parameter defines which state should be sent after threshold value 2 is exceeded.
Notice
The parameter is available only when parameter "Control value output format" is
set on "Priority".
Notice
The parameter is available only when parameter "Controller type" is set on
"Two-stage" or "Three-stage".
Product manual 2CKA001473B9679
Description of application and parameters
Off
On
End priority
OFF with priority
ON with priority
"Relative humidity" application
│191