Table of Contents
Advertisement
Planning and
Installation Guidelines
Technical Description
3.4 RUN Mode
The RUN-mode is the normal continuous operation mode of the input module, in which
no changes are made to the system.
In this mode of operation
Error Messages
If the input module does not have an error-free connection to at least one of the proximity switches
configured, the lighting of the display blinks and indicates the data of this sensor. If several proximity
switches are incorrect, then the device with the lowest number is indicated. All disturbed sensors
stand successively at the beginning of the internal list of the input module, so that with /\ and \/ the
display can be scrolled.
Error messages are acknowledged individually for each sensor with one single OK. The blinking of
the entire display disappears, if all error messages have been acknowledged.
After acknowledgement, the Err remains displayed with the sensor address as long as the sensor is
not error-free again.
Procedure
Display content *)
RUN
At least one
017
sensor has
an error
RUN
OK
023
RUN
OK
017
RUN
Cause for
017
error
eliminated
*) All sensor information and cell-ID identifications are examples
24
Planning and Installation Guidelines
Operation of the input module
• the display shows the data and conditions of the wireless proximity switches configured
in the system
017
sensor number (001 ... 120)
0 or 1
status of the sensor, not damped (0) or damped (1)
Err
announcement for the disturbance of a sensor, otherwise blank characters
12
Cell ID of the input module (1 ... 60)
blinking
at least one unacknowledged error message present
• it is possible to change between the displays of wireless proximity switch configured in the
system with the keys /\ and \/
• the error message of a wireless proximity switch can be acknowledged with OK.
• by pressing OK an error-free sensor can be triggered to provide the WINK-mode, so that its
green LED blinks
• by simultaneous pressing of the keys ESC and OK, the mode can be changed to the
configuration for further wireless proximity switches.
Operator
options
1 Err
12
/\ or \/
OK
/\ or \/
0 Err
12
OK
1 Err
12
/\ or \/
1
12
/\ or \/
Description
As sensor status the last message before the
disturbance is indicated.
Changes to the next sensor number, all disturbed
sensors are at the beginning of the list.
Acknowledgement of a disturbance and change to the
next (disturbed) sensor.
Changes to the next sensor number, all disturbed
sensors are at the beginning of the list.
Acknowledgement of a disturbance and change to the
next (disturbed) sensor.
After acknowledgement of all Error messages, only
the still existing error messages are still visible.
Changes to the next sensor number, all disturbed
sensors are at the beginning of the list.
The error marking goes out, if the error was eliminated
and an acknowledgement has been given afterwards.
Change to the next sensor number.
Wireless Proximity Switches / Issue: 09.2004
V 6
Advertisement
Table of Contents
