Step Controller - Priority At Measurement Failure; Step Controller - Percent Above Threshold 3 - ABB ClimaECO SBS/Ux.0.1 Series Product Manual

11.6.37 Step controller — Priority at measurement failure
Options:
If the internal or external measurement malfunctions or fails, a defined switching command can
be sent through this parameter.
Notice
The parameter is available only when parameter "Control value output format" is
set on "Priority".
11.6.38 Step controller — Percent above threshold 3
Options:
The parameter defines which state should be sent after threshold value 3 is exceeded.
Notice
The parameter is available only when parameter "Control value output format" is
set on "Percent".
Notice
The parameter is available only when parameter "Controller type" is set on
"Three-stage".
Product manual 2CKA001473B9679
Description of application and parameters
End priority
OFF with priority
ON with priority
0 ... 100 %
"Relative humidity" application
│195