Co2 Controller - Send Control Value At Change - ABB ClimaECO SBS/Ux.0.1 Series Product Manual

11.5.13 CO2 controller — Send control value at change
Options:
The control value is sent after a defined percentage change. If this is not desired, the parameter
must be set to "inactive".
Notice
The parameter is available only when parameter "Control value output format" is
set on "PI".
Product manual 2CKA001473B9679
Description of application and parameters
Inactive
In case of a change of 1%
In case of a change of 2%
In case of a change of 3%
In case of a change of 4%
In case of a change of 5%
In case of a change of 6%
In case of a change of 7%
In case of a change of 8%
In case of a change of 9%
In case of a change of 10%
In case of a change of 11%
In case of a change of 12%
In case of a change of 13%
In case of a change of 14%
In case of a change of 15%
In case of a change of 16%
In case of a change of 17%
In case of a change of 18%
In case of a change of 19%
In case of a change of 20%
In case of a change of 21%
In case of a change of 22%
In case of a change of 23%
In case of a change of 24%
In case of a change of 25%
Application "CO2 sensor"
│157