Pi Controller - Minimum Control Value; Pi Controller - Maximum Control Value; Pi Controller - Value At Measured Value Failure; Pi Controller - Blocking Object - ABB ClimaECO SBS/Ux.0.1 Series Product Manual

11.6.47 PI controller - Minimum control value

Options:
The parameter defines which value should be sent after the threshold value is undershot or
when the value is below this threshold value.
Notice
The parameter is available only when parameter "Controller type" is set on "PI".

11.6.48 PI controller - Maximum control value

Options:
The parameter defines which value should be sent after the threshold value is exceeded or
when the value is above the threshold value.
Notice
The parameter is available only when parameter "Controller type" is set on "PI".

11.6.49 PI controller - Value at measured value failure

Options:
If the internal or external measurement malfunctions or fails, a defined value can be sent
through this parameter.
Notice
The parameter is available only when parameter "Controller type" is set on "PI".

11.6.50 PI controller - Blocking object

Options:
The complete function of the sensor can be blocked using this parameter and the corresponding
communication object. Deactivation takes place by selecting "Inactive".
Notice
The parameter is available only when parameter "Controller type" is set on "PI".
Product manual 2CKA001473B9679
Description of application and parameters
0 ... 240
10 - 255
0 - 255
Inactive
Active
"Relative humidity" application
│199