Connecting The Antenna(S); Connecting The Grounding Cables; Connecting To Power Source - Alvarion BreezeACCESS Wi2 System Manual

Chapter 3 - Hardware Installation Wi² Extender
3.7.1

Connecting the Antenna(s)

To connect an external antenna:
1
Connect the external antenna directly to the N-type connector on the top panel of the Wi²
Extender unit.
NOTE
When connecting only one antenna, connect it to the right antenna connector. (When looking at the
unit from the side of the SU-ODU with the antenna connectors facing upwards, this is the
connector on the right.)
2
Set the antenna options for corresponding antenna through the user interface (refer to the AP
CLI Reference Guide).
CAUTION
If using antennas other than the Omni 8, make sure you do not exceed local radio regulations.
3.7.2

Connecting the Grounding Cables

To connect the grounding cables:
1
Connect a grounding cable to the grounding stud on theWi² Extender unit and tighten the
grounding screw firmly.
2 Connect a grounding cable to the grounding stud on the SU-ODU and tighten the grounding
screw firmly.
3 Connect the other ends of the grounding cables to a good ground (earth) connection.
CAUTION
Be sure that grounding is available and that it meets local and national electrical codes. For
additional lightning protection, use lightning rods, lightning arrestors, or surge suppressors.
3.7.3

Connecting to Power Source

1
Connect the power cable (see
supply.
56
Section 2.3.4) to the power socket on the unit and to the mains
BreezeMAX Wi² and BreezeACCESS Wi² System Manual