Example - Alvarion BreezeACCESS Wi2 System Manual

Chapter 7 - Network Configuration
7.7.2

Example

This example shows how to create two IP QoS profiles and associated them with a Virtual Network.
The two profiles are:
Voice: Provides voice traffic with high priority.
Web: Provides HTTP traffic with low priority.
7.7.2.1 Create the Profiles
1
Select Network > IP QoS, and then Add New Profile. The IP QoS Profile page opens.
2
Under Profile name, specify Voice.
3
Under Protocol, from the drop-down list select TCP.
4 Under Start port, from the drop-down list select SIP. Start port and End port are
automatically populated with the correct value: 5060.
5
Under Priority, from the drop-down list select Very High
Figure 7-12: Adding a New IP QoS Profile- Priority: Very High
6
Select Save.
NOTE
You could also create another profile using the same parameters but for UDP to cope with any kind
of SIP traffic.
7
On the IP QoS Profile page select Add New Profile.
8 Under Profile name, specify Web.
130
.
.
BreezeMAX Wi² and BreezeACCESS Wi² System Manual