Alvarion BreezeACCESS Wi2 System Manual page 60

Chapter 3 - Hardware Installation Wi² Extender
The following table describes the wireless status LEDs:
Right Pair
Off
Blinking-
slowly
Blinking-
fast
Blinking-
very fast
On
On
On
On
On
On
On
On
On
Once the AP has established a secure tunnel with a CTRL, the status lights revert to their normal
operation:
Power light is solid to indicate that the AP is fully operational
Ethernet light blinks to indicate the presence of traffic on the Ethernet port
Wireless light blinks to indicate the presence of traffic on the wireless port
38
11a LEDs Status
Center Pair Left Pair
Off Off
Off Off
Off Off
Off Off
Off Off
Blinking- Off
slowly
Blinking- Off
fast
Blinking- Off
very fast
On Off
On Blinking-
slowly
On Blinking-
fast
On Blinking-
very fast
On On
Description
The radio is disabled or unit is still booting up
No signal detected or RSSI is below -88 dBm
RSSI is between -88 dBm and -87 dBm
RSSI is between -86 dBm and -85 dBm
RSSI is between -84 dBm and -82 dBm
RSSI is between -81 dBm and -80 dBm
RSSI is between -79 dBm and -78 dBm
RSSI is between -77 dBm and -76dBm
RSSI is between -75 dBm and -74 dBm
RSSI is between -73 dBm and -72 dBm
RSSI is between -71 dBm and -70 dBm
RSSI is between -69 dBm and -68 dBm
RSSI is over -67dBm
BreezeMAX Wi² and BreezeACCESS Wi² System Manual