Adding The Slave Ap In A Group On The Controller - Alvarion BreezeACCESS Wi2 System Manual

NOTE
That the IP address showing in the "Discover using IP address" list should be your controller IP
address
8
Save your Configuration.
9
Restart the AP by clicking on the restart button on this page.
10.7.4

Adding the Slave AP in a Group on the Controller

1 The provisioned SLAVE AP should discover the Controller over the Mesh Link. (Leave the
SLAVE AP in the DEFAULT GROUP for now.)
NOTE
The Master and Slave APs can either share a group or be placed in different Groups. This section
shows the different groups path for simplicity.
2
Creat a new Group within the controller by clicking on "Controlled APs > Group Management
> Add a new group" (see
BreezeMAX Wi² and BreezeACCESS Wi² System Manual
Figure 10-16: Discovery Page
Figure 10-8)
How to Configure Local Mesh in Controlled Mode
195